mounting heated grips on throttle side
Posted: 03 May 2010 10:42
Found this on the net ... a different way than I do it (I leave a loop that sticks up above the brake master cylinder)
Here is how I have done it. I have had at least one case where when loading the bike the loop got grabbed.
http://www.mc4fun.net/2007%20525%20EXC/ ... H%2004.htm
"I wrap the wire once around the bars so if they break I have extra to work with.
I also helps not bend the wires so much on the throttle side."
Note sure I would go to this trouble on the left:
"Underneath the LH grip I have epoxyed a throttle tube to the bars and now use a throttle side grip which is thinner. This way the heat is the same on both sides."
Here is how I have done it. I have had at least one case where when loading the bike the loop got grabbed.
http://www.mc4fun.net/2007%20525%20EXC/ ... H%2004.htm
"I wrap the wire once around the bars so if they break I have extra to work with.
I also helps not bend the wires so much on the throttle side."
Note sure I would go to this trouble on the left:
"Underneath the LH grip I have epoxyed a throttle tube to the bars and now use a throttle side grip which is thinner. This way the heat is the same on both sides."